Pull Schedule Introduction
The Pull Schedule page is a play on the content that is normally present in Engineering drawings that define the physical beginning and end of a conductor in an installed system. In this instance the user will upload very similar data into the Inspextor system.
In the Auto Discovery process the Inpextor system locates and provides the MHT PoE devices an “ID Tag” to allow the internal database to recognize them and store the serial numbers of each device.
Initial Pull Schedule Configuration
It is important before you begin Pull Schedule configuration that the device you are working from can open an .xlsx (MS-XLSX) Microsoft Excel. If your machine can open the specified file type continue with the steps below.
- Access the Commissioning > Pull Schedule Page
- Note: in the photo above under the section FILENAME no file name is present
- Select Download Template
- Locate the file “clusterMap-v3.xlsx” in your default save location.
- Rename the Default File “PullSchedule”.
- Upload the “PullSchedule” file utilizing the “Import schedule” button.
Modifying Uploaded Pull Schedule
When Modifying the Pull Schedule, it is important to understand the state of the installation as well as the Pull Schedule page.
The page below is a sample that has a single instance of the Pull Schedule uploaded and Cluster Mapping is enabled. If the page is without a file in the Pull Schedule Table, the user will need to repeat the (Initial Pull Schedule Configuration Section). There are 2 methods for editing the Pull Schedule while in production.
The document can be downloaded and edited in Excel, or it can be edited inline using a pop out form.
Seeing the table above has a file listed shows that this instance of the Inspextor system has an uploaded Pull Schedule. It is important to understand the Action and how that section applies to the system.